Connect the ONT ethernet to your new router's WAN port. If you don't do this then the G1100 will get assigned a random IP via DHCP from your router and you'll have to look it up in your router's gui in order to connect to the G1100 via wifi.Ģ. It should not be in the new router's DHCP range because you don't want the new router to assign this address to another device on the network. It is the IP address you will use to access the G1100 admin gui once your network is setup. This is hard-coding the IP address of the G1100's LAN port. Set the Network(Home/Office) IP address to a fixed value in the new router's subnet like 192.168.1.2/255.255.255.0 Turns off DHCP because only my new router will be assigning IP addresses.ġb. Disable both Wireless Access Points and Broadband Connection (Network Connections -> Network(Home/Office)-> Edit -> Settings)ĭisables the WAN port because I want a "flat" network. This is because I'm only using my new router for wifi clients.ġb. Turn off 2.4 & 5 GHz wifi radios as described elsewhere Disconnect G1100 from ONT and connect to LAN port via ethernet to change settings so that it is no longer a router and is only a Moca bridge.ġa. Here is the solution that works great for me.ġ. Even if it works, you cannot access the G1100 admin gui while being connected to your new router because you're actually outside the G1100's subnet. They are setting up a network with 2 subnets, one for each router. both the accepted solution by JustinG and the Message #24 from Snapcard may result in NAT problems because by connecting I just finished working through setting up my own router as the primary router and using the Verizon G1100 only for Moca data to the Verizon STBs. Do i just need to follow the steps associated with number 1, with the CR1000A, since things are already going through my personal router as in Steps 2+?īridge G1100 So Your Router Becomes Primary We recently changed our Verizon Fios package and they shipped us a new router (CR1000A) with needing to ship our old Verizon Router back (G1100). I previously have performed this setup and have everything working as described. My question is based on the setup provided by jrmonta. In this thread user jrmonta provided these directions. Hello, there was an older thread about how to bridge the G1100 in order to use your own router and just use the G1100 for the On-Demand for the STB's.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |